6. Remove the speaker and speaker cable from the computer.
7. Route the new speaker cable and then position the new internal speaker tabs
8. Connect the speaker cable to the system board. See "Locating parts on the
9. Go to "Completing the FRU replacement."
Completing the FRU replacement
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
1. Ensure that all components have been reassembled correctly and that no tools
2. Replace the cover.
3. Reconnect the external cables and power cords to the computer. See "Rear
4. If you have replaced the system board, you must update (flash) the BIOS. See
3 into the metal speaker slots and then push the internal speaker downward
until the speaker locking tabs snap into position.
system board" on page 98.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside your computer.
connectors" on page 134.
"Flash update procedures" on page 251.
Chapter 10. Replacing FRUs - Menorca Computers
131