Removing The Leaf Digital Camera Back From The Camera Body; Connecting The Firewire Cable - Leaf Aptus II Installation Manual

Installation Procedures

Removing the Leaf Digital Camera Back from the Camera Body

Connecting the FireWire Cable

For information about connecting the FireWire cable, see Chapter 11,
Working in Tethered Mode.
Place the camera on a solid, steady surface.
1.
If any of the following cables are connected, disconnect them:
2.
•
FireWire cable
•
Camera-to-Back Sync cable
•
Flash Sync cable
Slide the Release button to the right side.
3.
Figure 8: Removing the Leaf Aptus digital camera back from a Mamiya RB
camera
Tilt the camera back away from the camera body to remove it.
4.
77
Release Button