How To Attach The Core Filter - JVC GR-HD1US Instructions Manual

How To Attach The Core Filter

Attach the core filters to the cables. The core filter
reduces interference.
Types of core filters
Size Cable
Large i.LINK cable*
USB cable**
Medium
Component video
cable***
DC cord
Small
Audio cable
* Optional
(If you have an optional JVC i.LINK cable
VC-VDV206U or VC-VDV204U with core
filters, it is not necessary to attach the provided
core filter. If you are going to use any other
i.LINK cable, attach the provided core filter.)
** Attach two core filters to both ends of the cable.
*** Not necessary to wind the cable.
The procedure below is an example of winding
cable once.
1
Release the stoppers on both ends of the core
filter.
Stopper
2
Run the cable through the core filter, leaving
approx. 3 cm of cable between the cable plug
and the core filter. Wind the cable once around
the outside of the core filter as shown in the
illustration.
● Wind the cable so that it is not slack.
3 cm
3
Close the core filter until it clicks shut.
Times to
wind
Twice
To attach the core filter to the component video
Once
cable
1) Release the stoppers on both ends of the core
—
filter.
2) Run the cable through the core filter, leaving
approx. 3 cm of cable between the cable plug
Once
and the core filter.
3) Close the core filter until it clicks shut.
NOTES:
● Take care not to damage the cable.
● When connecting a cable, attach the end with the
core filter to the camcorder.
Wind once.
EN
3 cm
9