Insert Editing (Dv Only) - JVC GR-HD1US Instructions Manual

NOTES:
When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
To perform Audio Dubbing while watching on the
television, make connections. (
To perform Audio Dubbing with a video unit
connected to the camcorder's S/AV connector, first
set "S/AV INPUT" to "A/V IN" or "S IN" in VIDEO
Menu. ( pg. 35, 41)
The "AUX" indication appears instead of "MIC".

Insert Editing (DV only)

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
A tape that was recorded in HD or SD mode cannot
be used for Insert Editing.
REW
STOP
NOTES:
Before performing the following steps, make sure
that "TIME CODE" is set to "ON". (
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
To perform Insert Editing while watching in the
television, make connections. (
1
Play back the tape, locate the Edit-Out point and
press PAUSE (9). Confirm the time code at this
point. ( pg. 42)
2
Press REW (3) until the Edit-In point is located,
then press PAUSE (9).
3
Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The "9I"
4
5
NOTES:
pg. 26)
START/STOP
INSERT
PLAY
PAUSE
pg. 35, 42)
pg. 26)
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
Press START/STOP to begin editing.
Confirm the insert at the time code you
checked in step 1.
To pause editing, press START/STOP. Press it
again to resume editing.
To end Insert Editing, press START/STOP, then
STOP (8).
During Insert Editing, set the Recording Mode
Switch to "DV".
Special Effects ( pg. 51) can be used to spice up
the scenes being edited during Insert Editing.
During Insert Editing, the date and time
information changes.
If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. (
If a memory card is loaded and "NAVIGATION" is
set to other than "MANUAL", a NAVIGATION
thumbnail image is stored in the memory card.
( pg. 52)
61
EN
pg. 76)