Table of Contents
Advertisement
64
EN
Select Scenes
FADE/WIPE
EFFECT
EDIT IN/OUT
6
Press PLAY (U) and then press R.A.EDIT ON/OFF
on the remote control.
The Random Assemble
Editing Menu appears.
7
If using a Wipe/Fader at
the beginning of the
scene, press FADE/WIPE
on the remote control.
Cycle through the
effects by pressing
repeatedly, and stop
when the one you want is displayed.
You cannot use a Picture Wipe/Dissolve at the
beginning of Program 1.
8
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.
9
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random
Assemble Editing Menu.
10
If using a Wipe/Fader at the end of the scene,
press FADE/WIPE.
Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
If you select a Wipe/Fader effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
You cannot use a Picture Wipe/Dissolve at the
end of the last scene.
When you use Fader/Wipe effects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolve).
11
If using Playback Special Effects, press EFFECT.
(
pg. 60)
12
Repeat steps 8 through 11 to register
additional scenes.
To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
If you are not using Wipe/Fader or Program AE
with special effects, repeat steps 8 and 9 only.
NOTES:
When choosing a scene, set Edit-In and Edit-Out
points so that there is a relatively large difference
between them.
PLAY
R.A.EDIT
ON/OFF
CANCEL
Selected parameter
N I
OUT
1
– –
– – : – – ~
2
~
~
3
4
~
5
~
6
~
7
~
8
~
T I ME
CODE
– – : – –
TOTAL
0
0 : 00
USING THE REMOTE CONTROL UNIT (cont.)
If the search time for an in-point exceeds
5 minutes, the recording deck's Record-Standby
mode will be cancelled and editing will not take
place.
If there are blank portions before or after the Edit-
In and Edit-Out points, a blue screen may be
included in the edited version.
Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
Turning off the camcorder's power erases all
registered Edit-In and Edit-Out points.
If you select Sepia or Monotone mode from
Special Effects, you cannot use the Dissolve or
Black & White Fader. In this case the Dissolve or
Black & White indicator begins blinking. Once the
MODE
next Edit-In point is registered, the effect is turned
off. To combine these effects, use Sepia or
Monotone during recording, then use the Dissolve
or Black & White Fader during Random Assemble
Editing.
It is not possible to use Wipe/Fader effects,
Program AE and Special Effects during Random
Assemble Editing using i.LINK cable.
Advertisement
Table of Contents
