decina ALEGRA AG1400WIO Installation & Owners Manual

Back-to-wall freestanding bath

Download this manual

A L E G R A B A C K - T O - W A L L F R E E S T A N D I N G B A T H

This manual provides the correct steps and care advice for a safe and long lasting installation.

Manufactured from premium sanitary grade acrylic, the Alegra freestanding back-to-wall bath is easy to install with

adjustable self-supporting feet. The unique Decina tile bead design allows it to be built into a tiled wall to save bathroom

THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED TRADESMAN

READ CAREFULLY

PRIOR TO COMMENCING

INSTALLATION

1 | DECINA INSTALLATION MANUAL

I N S T A L L A T I O N & O W N E R G U I D E

Thank you for purchasing a Decina Alegra Freestanding Bath.

space and makes cleaning easier.

AG1400WIO 1400(L) x 800(W) x 600(H) mm

PRE-INSTALLATION CHECKS

Unpack & check the item is correct & no damage has occurred during transit.

If there are any visible defects DO NOT PROCEED WITH THE INSTALLATION &

please contact the place of purchase immediately. ANY CLAIMS FOR DAMAGE

WILL NOT BE ACCEPTED AFTER INSTALLATION.

Protect your bath before & during installation, scratches &/or cracks &/or surface

damage sustained during or after the installation are not covered by warranty.

Installation must be in accordance with building regulations & local authority

requirements.

Need help?

Do you have a question about the ALEGRA AG1400WIO and is the answer not in the manual?

Page 1 Manufactured from premium sanitary grade acrylic, the Alegra freestanding back-to-wall bath is easy to install with adjustable self-supporting feet. The unique Decina tile bead design allows it to be built into a tiled wall to save bathroom space and makes cleaning easier.
Page 2 Mark the desired position of the bath on the floor and wall. Install a waterproof wall lining or Brick or timber stud wall villaboard. Finish flooring. Villaboard Waterproof membrane Tiles Mark the floor and outline of the bath 2 | DECINA INSTALLATION MANUAL...
Page 3 INSTALLATION STEPS STEP 4. Carefully tilt the bath on its side and connect it to the drain outlet. We recommend using a Decina OWA018 Pop down overflow waste. Before finishing, water test for leaks and correct Waste drainage. Fill the freestanding bath with water and check the water flows easily to the waste outlet.
Page 4 *Warranty T&Cs apply. All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right to modify or change models without notice. Please confirm all particulars with your sales consultant prior to purchase. For further information and for warranty T&C’s, please visit decina.com.au...

Alegra 1400 io fsb