decina ALEGRA AG1500BTWCNW Installation  & Owners Manual

decina ALEGRA AG1500BTWCNW Installation & Owners Manual

Freestanding back-to-wall contour spa bath

Advertisement

Quick Links

A L E G R A F R E E S T A N D I N G B A C K - T O - W A L L C O N T O U R S P A B A T H
This manual provides the correct steps and care advice for a safe and long lasting installation.
Manufactured from premium sanitary grade acrylic, Decina's freestanding spa baths are easy to install,
with adjustable self-supporting feet & can be freely located anywhere in your bathroom.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED TRADESMAN
READ CAREFULLY
PRIOR TO COMMENCING
INSTALLATION

MAINTENANCE

DECINA USES THE HIGHEST SANITARY GRADE ACRYLIC, HOWEVER NAKED FLAMES, CIGARETTES OR STRONG CHEMICALS
SHOULD BE AVOIDED & REMOVED IMMEDIATELY TO PRESERVE THE HIGH GLOSS ACRYLIC SURFACE:
When filling the bath start with cold water to allow the bath to gradually adapt to the temperature.
!
After using your bath clean with a soft cloth & warm soapy water to clean any oils or soap, to prevent tide marks
!
& preserve the polished surface.
Clean using warm soapy water & only mild liquid detergents. Do not use powders, pastes, creams, chemicals, window
!
cleaning sprays or abrasive cleaners.
Cream cleaners may only be used to remove stubborn marks.
!
Scratches can be removed with a fine polish like Brasso.
!
1 | DECINA INSTALLATION MANUAL
I N S T A L L A T I O N & O W N E R G U I D E
Thank you for purchasing a Decina Alegra Freestanding Spa Bath.
AG1500BTWCNW (12 jets) 1500(L) x 800(W) x 590(H) mm
AG1700BTWCNW (12 jets) 1700(L) x 800(W) x 590(H) mm

PRE-INSTALLATION CHECKS

Unpack & check the item is correct & no damage has occurred during transit.
!
If there are any visible defects DO NOT PROCEED WITH THE INSTALLATION & please contact
!
the place of purchase immediately. ANY CLAIMS FOR DAMAGE WILL NOT BE ACCEPTED
AFTER INSTALLATION.
Protect your spa bath before & during installation, scratches &/or cracks &/or surface
!
damage sustained during or after the installation are not covered by warranty.
Installation must be in accordance with building regulations & local authority requirements.
!
Electrical installation must comply with AS:3000 - Electrical Wiring Rules.
!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ALEGRA AG1500BTWCNW and is the answer not in the manual?

Questions and answers

Summary of Contents for decina ALEGRA AG1500BTWCNW

  • Page 1 This manual provides the correct steps and care advice for a safe and long lasting installation. Manufactured from premium sanitary grade acrylic, Decina’s freestanding spa baths are easy to install, with adjustable self-supporting feet & can be freely located anywhere in your bathroom.
  • Page 2 Ensure the bath is level so all water can drain to the waste outlet. 3-5mm gap between the bottom of the bath & the floor 2 | DECINA INSTALLATION MANUAL...
  • Page 3 24 h SILICONE Silicone inside and outside of the shower (silicone not supplied). Measure the distance from the wall to the centre of the elbow. This is the centrepoint for the pump to be installed on. 3 | DECINA INSTALLATION MANUAL...
  • Page 4 *Warranty T&Cs apply. All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right to modify or change models without notice. Please confirm all particulars with your sales consultant prior to purchase. For further information and for warranty T&C’s, please visit decina.com.au...

This manual is also suitable for:

Alegra ag1700btwcnw

Table of Contents