Computer Setup-Boot - HP Pro 3000 SFF Maintenance And Service Manual

Table 3-3 Computer Setup—Advanced (continued)
Option
Onboard Serial Port 1
PCI Device SERR#
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-4 Computer Setup—Boot
Option
F9 Boot Menu
F10 Setup Prompt
F11 Recovery
F12 Boot from LAN
Prompt
Hard Disk Boot Seq.
Optical Drive Boot
Seq.
Network Boot Seq.
First Boot Device
Second Boot Device
Third Boot Device
Fourth Boot Device
Description
Allows you to select a setting for the onboard serial port:
●
Disabled
●
3F8/IRQ4
●
2F8/IRQ3
●
3E8/IRQ4
●
2E8/IRQ3
Disables/enables SERR#.
Description
Disables/enables F9 Boot Menu.
Disables/enables the F10 Setup prompt message on the logo screen.
Disables/enables F11 Recovery and provides the option of showing the F11 Recovery prompt
message on the logo screen. Choose from the following:
●
Disabled
●
Enabled no prompt
●
Enabled and prompt
Disables/enables the F12 Boot from LAN prompt message on the logo screen.
Allows you to specify the order of attached hard drive devices (such as USB HDD storage or USB
flash media). The first drive in the order has priority in the boot sequence and is recognized as
drive C (if any devices are attached).
Allows you to specify the order in which attached optical drives (including USB ODD) are checked
for a bootable operating system image.
Allows you to specify the order in which network devices (including UP NIC cards) are checked for
a bootable operating system image.
Allows you to specify which devices will boot first, second, third, and fourth or to disable any of the
four:
●
Removable
●
CDROM
●
Hard Disk
●
Network
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating
system has started.
HP Pro 3000/3080 – Computer Setup (F10) Utility 17