Installing An Optical Drive Into The 5.25-Inch Drive Bay - HP Pro 3000 SFF Maintenance And Service Manual

NOTE: To install an optical drive, refer to
on page 57.

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank.
5. If you are adding a drive to an empty lower optical drive bay, you must remove the knockout
plate from the bay. To do so, insert a flat screwdriver into the knockout plate slot and rotate the
screwdriver to break the knockout plate out of the chassis. Discard the knockout plate.
6. If the new drive has screws installed on the sides of the drive, remove the screws before
inserting the drive into the chassis.
7. Slide the drive in through the front of the chassis (1) until the screw holes on the drive are
aligned with the screw holes on the drive cage and install the two M3 metric retainer screws (2)
as shown in the following illustration.
NOTE:
M3 metric retainer screws for optical drives are black.
Figure 6-20
8. If the system configuration includes only one optical drive, connect the SATA data cable to the
white system board connector labeled SATA2. If you are adding a second optical drive, connect
the SATA data cable to the orange system board connector labeled SATA4.
(Access Panel on page
(Front Bezel on page
Extra drive retainer screws are provided on the interior of the front bezel if needed. The
Installing the Optical Drive
Installing an Optical Drive into the 5.25-inch Drive Bay
(Preparation for Disassembly on page
36).
37).
35).
Drives 57