HP Compaq dc7800 Reference Manual page 52

Table 4-1 Security Features Overview (continued)
Option
Pre-Boot Authorization
Smart Cover
Embedded Security
Device Security
Network Service Boot
System IDs
DriveLock (some models)
For more information about Computer Setup, see the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD.
Support for security features may vary depending on the specific computer configuration.
40 Chapter 4 Desktop Management
Description
Allows you to enable/disable the Smart Card to be used in place of the Power-
On Password.
Allows you to:
●
Enable/disable the Cover Lock.
●
Enable/disable the Cover Removal Sensor.
NOTE: Notify User alerts the user that the sensor has detected that the
cover has been removed. Setup Password requires that the setup password
be entered to boot the computer if the sensor detects that the cover has been
removed.
This feature is supported on some models only. See the Computer Setup
(F10) Utility Guide on the Documentation and Diagnostics CD for more
information.
Allows you to:
● Enable/disable the Embedded Security device.
●
Reset the device to Factory Settings.
This feature is supported on some models only. See the HP ProtectTools
Security Manager Guide at http://www.hp.com
Enables/disables serial ports, parallel port, front USB ports, system audio,
network controllers (some models), and SCSI controllers (some models).
Enables/disables the computer's ability to boot from an operating system
installed on a network server. (The network controller must reside on the PCI
bus or be embedded on the system board.)
Allows you to set:
●
Asset tag (18-byte identifier) and ownership Tag (80-byte identifier
displayed during POST). See the Computer Setup (F10) Utility Guide
on the Documentation and Diagnostics CD for more information.
●
Chassis serial number or Universal Unique Identifier (UUID) number.
The UUID can only be updated if the current chassis serial number is
invalid. (These ID numbers are normally set in the factory and are used
to uniquely identify the system.)
Keyboard locale setting (for example, English or German) for System ID
entry.
Allows you to assign or modify a master or user password for ATA hard drives.
When this feature is enabled, the user is prompted to provide one of the
DriveLock passwords during POST. If neither is successfully entered, the
hard drive will remain inaccessible until one of the passwords is successfully
provided during a subsequent cold-boot sequence.
NOTE: This selection will only appear when at least one ATA drive that
supports the ATA Security command set is attached to the system.
See the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD for more information.