Type 1 Battery Holder; Type 2 Battery Holder - HP Compaq dc7800 Reference Manual

CAUTION:
equipment. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object.
1. Prepare the computer for disassembly
2. Remove the access panel
NOTE:
3. Locate the battery and battery holder on the system board.
4. Depending on the type of battery holder on your system board, complete the following instructions
to replace the battery:

Type 1 Battery Holder

1. Lift the battery out of its holder.
2. Slide the replacement battery into position, positive side up.
3. The battery holder automatically secures the battery in the proper position.
4. Replace the computer access panel.
5. Plug in the computer and turn on power to the computer.
6. Reset the date and time, your passwords, and any special system setups, using Computer Setup.
Refer to the Computer Setup (F10) Utility Guide.

Type 2 Battery Holder

1. To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
Static electricity can damage the electronic components of the computer or optional
(Computer Access Panel on page
It may be necessary to remove an expansion card to gain access to the battery.
(Preparation for Disassembly on page
113).
107).
Battery 157