Installing An Optical Drive Into The 5.25-Inch Drive Bay - HP Compaq dc7800 Reference Manual
Business pc
Hide thumbs
Also See for Compaq dc7800:
- Technical reference manual (102 pages) ,
- Troubleshooting manual (70 pages) ,
- Quickspecs (67 pages)
Table of Contents
Advertisement
5.
Rotate the drive cage back down to its normal position.
CAUTION:
6.
Press the green drive retainer latch (1) located on the right side of the drive to disengage the drive
from the drive cage. While pressing the drive retainer latch, slide the drive back until it stops, and
then lift it up and out of the drive cage (2).
To replace the optical drive, reverse the removal procedure.
NOTE:
When replacing a drive, transfer the four guide screws from the old drive to the new one.
Installing an Optical Drive into the 5.25-inch Drive Bay
To install an optional 5.25-inch optical drive:
1.
Prepare the computer for disassembly
2.
Remove the access panel
Be careful not to pinch any cables or wires when rotating the drive cage down.
(Computer Access Panel on page
(Preparation for Disassembly on page
107).
113).
Drives 131
Advertisement
Table of Contents
