HP OmniBook 7100 Reference Manual page 92

Using the Recovery CD
You can use the OmniBook Recovery CD to recover an original OmniBook build, or
you can use it to install the HP custom software over a user-installed alternate
operating system.
The Recovery CD provides the OmniBook-specific drivers to configure your custom
system. The drivers for Windows 95, Windows NT 4.0, and Windows for Workgroups
are located in these places:
On the Recovery CD ROM, under \Omnibook\Drivers.
On the OmniBook hard drive under C:\Omnibook\Drivers.
On the OmniBook website at
contains the latest updates of software drivers.
The OmniBook Recovery CD contains the following:
README.TXT text file Instructions for using the Recovery CD .
RECOVER\
ENC Encoded image of the factory load—either Windows 95 or Windows NT 4.0.
BOOTDISK For creating your own copy of a boot disk (like the Support Utility disk).
FILE.CHK Checksum list. Used to verify that software recovery was successful.
OMNIBOOK\
Use this to install the online User's Handbook or to copy the OmniBook Notes
HPUTILS
and Support files to the \OmniBook directory on your hard drive.
DRIVERS Use this to manually install individual audio, video, infrared, and PC-Card
(PCMCIA) drivers for Windows NT 4.0, Windows 95, and Windows for
Workgroups. Look for the specific driver for the specific version of your operating
system. Each driver has a README file with instructions.
MANUALS Use this for viewing of the online User's Handbook from the CD, not for its
installation.
6-2
. This website