Fence - Grizzly G0604ZX Owner's Manual

Fence

Components and Hardware Needed:
Carriage ............................................................. 1
Fence ................................................................. 1
Cap Screws M10-1.5 x 30 ................................. 2
Flat Washers 10mm .......................................... 2
Cap Screws M8-1.25 x 30 ................................. 2
To install the fence:
1.
Attach the fence carriage to the back of the
table base (see Figure 13), but do not fully
tighten the bolts yet.
Figure 13. Fence carriage installed.
2.
Place a piece of paper on the table and slide
the carriage over the table top to allow it to
rest on the paper and self align, as shown in
Figure 14, then tighten the carriage mounting
bolts.
Note: The paper will keep the carriage from
making direct contact with the table, which
will keep the fence from dragging across the
table when it is installed.
G0604 6" X 56" Jointer
Qty
Figure 14. Carriage slide propped up on paper.
3.
Attach the fence to the carriage, as shown in
Figure 15.
Figure 15. Attaching fence to carriage.
4. Install the tilt lever as shown in Figure 16.
Figure 16. Installing the fence tilt lever.
-17-