Important Safety Information - Greenlee 555 Instruction Manual

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to
hazards or unsafe practices which could result in
an injury or property damage. The signal word,
defined below, indicates the severity of the hazard.
The message after the signal word provides
information for preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL
result in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning will
result in severe injury or death.
Do not use this tool in a hazardous
environment. Hazards include
flammable liquids, gases, or other
materials. Using this tool in a
hazardous environment can result
in a fire or explosion.
Failure to observe this warning will
result in severe injury or death.
Greenlee Textron / Subsidiary of Textron Inc.
555 Electric Bender
SAFETY
ALERT
SYMBOL
Electric shock hazard:
• Connect the power cord to a
15 amp receptacle on a ground
fault protected circuit only. See
Grounding Instructions.
• Do not modify the power cord or
plug.
• Inspect the power cord before use.
Repair or replace the cord if
damaged.
• Disconnect from power before
servicing.
Failure to observe this warning can
result in severe injury or death.
• Do not expose to rain.
• Do not use in wet or damp
locations.
Failure to observe these warnings
can result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris.
Do not remove guards.
Failure to observe this warning can
result in severe injury or death.
3 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070