Table of Contents
Advertisement
USE AND OPERATION
3.5.4 Bluetooth Manager Device Setup
In order to enable a Bluetooth device for communication with the Rhino-NET™/ RF-3 EU BT
Low Temp terminal you must perform the discovery procedure and enable the device as
follows:
1. Place the Bluetooth device within range of the Rhino-NET™ terminal (10 meters).
2. From the Rhino-NET™ Control Panel, select and run the Bluetooth Device Properties
applet.
3. Run the Discovery procedure: "Scan Device". The following window will appear.
4.
5. Move the discovered device (the one with the Activesync icon, see figure) to the Trusted
list.
6. Activate the device as shown below.
7.
8. Close the Bluetooth Manager by selecting OK.
The Bluetooth connection will be established by Rhino-NET™ (Master) upon redirection of
the Port to Bluetooth, see par. 3.5.3.
3
25
Advertisement
Table of Contents
