Important Note - Intex FastFill AP619MP2 Owner's Manual

Note: Airbeds stretch over time such that some air may need to be added to the entire
airbed to maintain desired firmness and stability. Alternatively, you may start with
step 2 to firm up both chambers simultaneously, and then proceed with adjusting the top
chamber.
Never disconnect the power cord from the electrical outlet while the pump is running.
Rotate Air Chamber Selection Dial to (
the power cord.
INFlATION OPTION
1. If electrical power is not available then a conventional foot or manually operated air
pump can be connected to the manual inflation port.
2. Turn the air chamber selection dial to "Both air chambers" mark (
chamber" position (
nozzle into the manual inflation port to inflate the airbed. See Fig (6).
619MP2
3. When the airbed is fully inflated to the desired firmness, turn the air chamber selection
dial to ( ) mark first, this will prevent air from escaping from the chambers, then
remove the air pump nozzle.
Note: Inflate only with a low pressure inflator. Do not over inflate. Fill with cold air only.

IMPORTANT NOTE

Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel. Do not expose the airbed to extreme temperatures
(hot or cold). Stretching is a natural characteristic of new vinyl. During initial use, the airbed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
READ AND SAVE THESE INSTRUCTIONS
(22PO) AP619MP2 ELECTRIC PUMP ENGLISH 4.875" X 7.25" 12/15/2021
619MP2
IMPORTANT
) position to turn off the pump before disconnecting
619MP2
) or "Bottom air chamber" position (
Page 4
619MP2
619MP2
), then insert the air pump
FIg (6)
22
PO
), or "Top air