Inflation - Intex FastFill AP620DA Owner's Manual

INFLATION

1. Open cord compartment cover and remove power cord. See Fig (1).
2. Plug in the AC power cord into an AC electrical outlet. See Fig (2).
3. Press the inflation button (
4. When the air bed is inflated to the desired firmness, press "
Note: The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended or when air bed is fully inflated.
FIG (3)
5. Lie down on the air bed to test the firmness.
6. If the air bed feels too firm, adjust the firmness by pressing the deflation button (
deflate. See Fig (4).
NOTE: This will start deflating the air bed quickly, press "
second or so. Test the firmness and repeat for a second at a time until you have reached
the desired firmness.
Alternatively, you can do this process by pressing the deflation adjust button "
will allow air to be released slowly and short. See Fig (5). It will automatically return to
the closed state after completion, press "
reaches the desired firmness.
IMPORTANT NOTE
Proper inflation of the air bed.
The ambient temperatures of air have an effect on the air bed internal pressure. At low
ambient temperature the air will contract within the air bed and the air bed will feel softer:
add air as necessary. At high ambient temperature the air within the air bed will expand
significantly and the air bed will become hard and may burst: release air to avoid damage
to the air bed or to soften the feel. Do not expose the air bed to extreme temperatures
(hot or cold). Stretching is a natural characteristic of new vinyl. During initial use, the air
bed may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the air bed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
SAVE THESE INSTRUCTIONS
FIG (1)
) to inflate. See Fig (3).
(20IO) AP620DA ELECTRIC PUMP ENGLISH 4.875" X 7.25" 04/18/2023
220V – 240V
√
FIG (4)
" again to switch OFF after a
" again to repeat deflating until the air bed
Page 3
110V – 120V
FIG (2)
" again to switch OFF.
FIG (5)
) to
", which
20
IO