Inflation Option - Intex FastFill I637USB Owner's Manual

IMPORTANT NOTE
Proper inflation of the air bed.
The ambient temperatures of air have an effect on the air bed internal pressure. At low
ambient temperature the air will contract within the air bed and the air bed will feel softer:
add air as necessary. At high ambient temperature the air within the air bed will expand
significantly and the air bed will become hard and may burst: release air to avoid damage
to the air bed or to soften the feel. Do not expose the air bed to extreme temperatures (hot
or cold). Stretching is a natural characteristic of new vinyl. During initial use, the air bed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the air bed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.

INFLATION OPTION

If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the line cord
compartment. Do not use high-pressure air compressors. See Fig (8). Follow these steps:
1. Open line cord compartment cover and locate the
manual inflation port.
2. Make sure the control dial of the internal electric
pump is still in the off mark (
3. Remove the cap from the manual inflation port and
insert the nozzle of the pump into the port. Inflate the
air bed to desired firmness.
NOTE: Do not overinflate. The firmness should be
approximately the same as the level achieved with the
internal electric pump.
4. Remove nozzle from manual inflation port and close the cap and the line cord cover.
READ AND SAVE THESE INSTRUCTIONS
(37PO) I637USB USB PUMP ENGLISH 4.875" X 7.25" 05/17/2022
) position.
Page 4
37
PO
FIG (8)