Gigabyte GA-EX58-EXTREME User Manual page 96

Smart Backup Config
Apply RAID Config
=== Disk Info ===
[Port] [Model]
Port 0 WDCWD800JD-00JNA0
Port 1 WDCWD800JD-22LSA0
=== RAID Info ===
[Level] [Capacity] [Member]
Performance 0GB
: Move
Enter: Select
F5: Previous Values
Step 4:
After configuring the SATA ports, you are ready to proceed with the installation of the operating system.
You do not have to load the SATA controller driver during the installation process of the operating
system. Make sure to install the driver after the operating system is installed (using "Xpress Install" to
install all drivers required for your motherboard is recommended) for the SATA hard drives to work and
be detected properly.
Step 5:
Then install the Smart Backup utility from the Application Software menu on the driver Autorun screen
for monitoring the device/RAID status in the operating system (for more information, refer to section 5-
1-5, "Smart Backup Utility").
GA-EX58-EXTREME Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Smart Backup Config
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Performance (RAID 0)]
[Press Enter]
[Capacity]
80GB
80GB
F10: Save
Figure 2
- 96 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults