Gigabyte GA-EX58-EXTREME User Manual page 62

Smart Backup

Controller 0 (GSATA2 0/1)

Controller 1 (GSATA2 2/3)
: Move
Enter: Select
F5: Previous Values
The Controller 0 (GSATA2 0/1)/Controller 1 (GSATA2 2/3) submenu allows you to check the
information of the hard drive(s) connected to the GSATA2_0~3 connectors or to configure a RAID array.
The Controller 0 (GSATA2 0/1) supports the GSATA2_0 and GSATA2_1 connectors and the Control-
ler 1 (GSATA2 2/3) supports the GSATA2_2 and GSATA2_3 connectors. After the configuration, ensure
the SATA controller driver has been installed in the operating system. You can install the Smart Backup
utility (refer to Chapter 5, "Configuring SATA Hard Drive(s)," to view the device status in the operating
system.
Controller 0 (GSATA2 0/1)/ Controller 1 (GSATA2 2/3)

Disk/RAID Status

Smart Backup Config
: Move
Enter: Select
F5: Previous Values
GA-EX58-EXTREME Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Smart Backup
[Press Enter]
[Press Enter]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Controller 0 (GSATA2 0/1)
[Press Enter]
[Press Enter]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
F10: Save
F10: Save
- 62 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults