Target MINSMERE CANED CHEST 2 DOORS Manual

MINSMERE CANED CHEST 2 DOORS
Congratulations on your latest Target purchase.
Now what? Don't start sweating over this box of parts. This will be easy. We did the hard work
for you. All you need to do is follow our simple instructions and you'll be on your way to
transforming your patio in no time.
Good luck -- though we're confident you won't need it.
Before you begin
Check for damaged or missing part. Call 1-855-MYTGTHOME (1-855-698-4846) to order
missing supplies.
Use the carton as a working surface to prevent product damage during assembly.
Gather all tools prior to assembly.
Do not use power tools for assembly. Use screwdriver and allen key.
DISCLAIMER: This video incorporates the instructions provided by the manufacturer with this product.
Target will not be liable for any damage or injury based on your reliance on the content provided.
The required hardware parts are:
The bolts are labeled as (H1) x 4.
The ½" pan-head screws are labeled as (H2) x 30.
The cam lock bolts are labeled as (H3) x 18.
The cam locks are labeled as (H4) x 18.
The handle bolts are labeled as (H5) x 4.
The handles are labeled as (H6) x 2.
The wooden dowels are labeled as (H7) x 8.
The shelf pins are labeled as (H8) x 4.
The hinges are labeled as (H9) x 4.
The washers are labeled as (H10) x 4.
The allen key is labeled as (H11) x 1.
The ¾" pan-head screws are labeled as (H12) x 2.
The plastic restraint is labeled as (H13) x 2.
The parts for assembly are identified alphanumerically for ease.
The top panel is labeled as A.
The left assembly is labeled as B.
The right assembly is labeled as B1.
The two doors are labeled as C.
The shelf panel is labeled as D.
The shelf assembly is labeled as D1.
The bottom assembly is labeled as E.
The back panel is labeled as F.
HOW TO USE CAM LOCK SYSTEM
The cam lock bolt is inserted and screwed into the respective hole on the panel. The cam lock is
inserted and secured in the hole present on the panel to be attached, with the arrow feature on
cam lock top pointing to the end of frame. The cam locks are rotated clockwise 180° to lock
parts together. The panel should be tight against each other and connection should be rigid.