Bosch wireless PerfectRoast Information For Use page 10

EN
Requirements
¡ The wireless food probe is clean.
→ "Cleaning the wireless food probe", Page 12
The charging station is sufficiently charged.
¡
→"Charging the charging station/range extender", Page 10
▸ Place the wireless food probe onto the charging station.
D The Bluetooth
charging
Note: If the Bluetooth
probe is on the charging station, make sure that the metal ring
and the probe are connected to the charging contacts.
5.2 Charging the charging station/range
extender
Charge the charging station as soon as the battery is empty.
ATTENTION!
Very high ambient temperatures may damage the charging
station.
▸ Do not exceed an ambient temperature of 10°C to 35°C.
▸ Store the charging station in a dry place.
▸ Do not place the appliance on or near hot surfaces such as
hobs.
1. Connect the charging station using the USB cable supplied.
2. Connect the USB cable to the power supply and plug it into
the socket.
Notes
The charging station goes into standby mode after 10 minutes
when the battery is fully charged. The green LED stays lit as
long as the USB supply is connected.
¡ Only charge with a certified USB power supply (5V
min 1A, max 3A) that complies with the relevant regulations
and standards in the country of destination.
¡ This appliance contains batteries that cannot be replaced.
When the battery has reached the end of its service life, the
appliance must be disposed of properly.
10
_Bluetooth_Meatprobe_BO_9001868535.indd 10 _Bluetooth_Meatprobe_BO_9001868535.indd 10
LED is off while the wireless food probe is
®
LED flashes while the wireless food
®
,
22.03.24 08:38 22.03.24 08:38