Programming The Remote Control - Gateway 46-inch User Manual

Programming the remote control

The TV component button has been preset to work with your Gateway
plasma TV (program code 0077). You can program the remote control to work
with as may as seven other components.
To program the remote to control other components:
1
Turn on the component.
2
Press the matching component button on the remote control.
3
Press and hold
4
Enter the programming code for the component and manufacturer. For a
list of component programming codes, see "Component program codes"
on page 8. If the code is accepted, the LED flashes twice after the last digit
is entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next
code listed for the component and manufacturer.
Important
5
Point the remote control at the component and press
component should turn off.
Tips & Tricks
until the LED flashes twice.
SETUP
Make sure that you try all the codes listed until you find
the one that works for the component.
If you cannot find your manufacturer in the component list
or the program code does not work, you can use the
remote control to search for the correct component code.
See "Searching for component codes" on page 19.
www.gateway.com
Programming the remote control
. The
POWER
7