Programming The Remote Control; Searching For Component Codes - Gateway 30-inch User Manual

Programming the remote control

The TV component button has been preset to work with your Gateway LCD TV (program
code 0080). You can program the remote control to work with as many as seven other
components.
To program the remote to control other components:
1
Turn on the component using the component's power button.
2
Press the matching component button on the remote control.
3
Press and hold the
4
Enter the programming code for the component and manufacturer. For a list of
component programming codes, see
accepted, the LED flashes twice after the last digit is entered.
If the LED does not flash twice, repeat
for the component and manufacturer.
Important
5
Point the remote control at the component and press
turn off.
Tips & Tricks

Searching for component codes

If you cannot find your manufacturer in the component list or the program code does
not work, you can use the remote control to search for the correct component code.
To search for a component code:
1
Turn on the component.
2
Press the matching component button on the remote control.
button until the LED flashes twice.
SETUP
If there is more than one code listed for the component and
manufacturer, make sure that you try all the codes listed to find the
one that works for the component.
If you cannot find your manufacturer in the component list or the
program code does not work, you can use the remote control to
search for the correct component code. See
component codes" on page
www.gateway.com
"Component codes" on page
Step 2 through Step 4
POWER
"Searching for
7.
14. If the code is
with the next code listed
. The component should
7