NEC MultiSync M431 Setup Manual page 6

Please refer to the instructions included with the optional mounting
equipment for detailed information about attaching or removing.
Do not cover the vent on the product. Improper installation of the product
may result in damage to the product, an electric shock or fire.
Do not install the product in the locations below:
• Poorly ventilated spaces.
• Near a radiator, other heat sources, or in direct sunshine.
• Continual vibration areas.
• Humid, dusty, steamy, or oily areas.
• An environment where there are corrosive gases (sulfur dioxide,
REQUIRED
hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone, etc.).
• Outdoors.
• High-temperature environment where humidity changes rapidly and
condensation is likely to occur.
• A ceiling or wall that is not strong enough to support the product and
mounting accessories.
Do not mount the product upside down.
Prevent tipping and falling for earthquakes or other shocks.
To prevent personal injury or damage to the product caused by tipping
over due to earthquakes or other shocks, make sure to install the product
in a stable location and take measures to prevent falling.
The measures to prevent falling and tipping are intended for reducing
the risk of injury, but may not guarantee the effectiveness against all
earthquakes.
The product may tip causing personal injury.
• When using the product with the
optional table top stand, fasten
the product to a wall using a cord
or chain that can support the
REQUIRED
weight of the product in order to
prevent the product from falling.
Depending on the table top
stand, the stand has the structure
for preventing tipping.
Please refer to the table top
stand manual.
• Be sure to remove the cord or chain from the wall before moving the
product to prevent personal injury or damage to the product.
WARNING
M651-2
Cord or chain
English-4