RECARO C 7000 Installation Instructions Manual page 56

10. Deactivate the express down mechanism.
11. Reset the height adjustment so that it is in the highest position.
Z
1
3
12. Screw the two centre screws (2) from the installation kit into the adapter (finger-tight only).
13. Now slide the seat as far back as possible.
14. Screw the two front screws (3) into the adapter using the stipulated torque. (T30 Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
15. Now slide the seat as far forward as possible.
16. Tightly screw the four rear screws (2, 4) into the adapter using the stipulated torque.
Torque: M8 screws: 25 Nm ± 2 Nm
Danger:
If the torque is not set correctly, the screws will work loose whilst you are driving.
In this case, the safety concept can no longer be ensured and the vehicle may no longer be used.
The screws must be tightened using the stipulated torque.
RECARO Automotive Seating
1 RECARO seat
2 Centre screws - M8 from installation kit
3 Front screws - M8 from installation kit
4 Rear screws - M8 from installation kit
4
2
Page 25 of 31