Turn Advisory And Arrival Annunciations - Garmin GNS 530W Pilot's Manual & Reference

VLOC remote transfer key is stuck — (GNS 530W
only) The remote VLOC transfer switch is stuck in the
enabled (or "pressed") state. Try pressing the switch again
to cycle its operation. If the message persists, contact your
Garmin dealer for assistance.
VLOC transfer key stuck — (GNS 530W only) The
VLOC flip-flop key is stuck in the enabled (or "pressed")
state. Try pressing the VLOC flip-flop key again to cycle
its operation. If the message persists, contact your Garmin
dealer for assistance.
Waypoint already exists — The name you have entered
for a user waypoint already exists in memory.
Waypoint(s) have been replaced — One or more user
waypoints were updated during a unit-to-unit crossfill
operation.
Waypoint memory is full — You have used all 1000 user
waypoint locations in the 500W-series unit memory. Delete
unwanted waypoints to make room for new entries.

Turn Advisory and Arrival Annunciations

The following annunciator messages may appear in the
lower right corner of the 500W-series unit display:
Arriving at waypoint — Arriving at the destination
waypoint for the active leg.
Hold direct — "Direct" holding pattern entry.
Hold parallel — "Parallel" holding pattern entry.
Hold teardrop — "Teardrop" holding pattern entry.
Left to xxx° in xx sec — Turn advisory. Turn to the indi-
cated heading by the time shown.
Left to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.
Next DTK xxx° in xx sec — Waypoint alert. Prepare to
turn to the indicated heading upon waypoint passage.
PTK end in xx sec — Parallel Offset is terminating.
Right to xxx° in xx sec — Turn advisory. Turn to the
indicated heading by the time shown.
Right to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.
12 - MESSAGES
ABBREVIATIONS &
NAV TERMS
197