Using the self-cleaning upper and lower ovens.
The oven doors must be closed and all controls set correctly for the cycle to work properly.
30
How to Delay the Start of Cleaning
... T ouch.the.SELF CLEAN.pad .
A.3-hour.self-clean.time.is.recommended.
for.use.when.cleaning.small,.contained.
spills . . A.self-clean.time.of.5.hours.is.
recommended.for.a.dirtier.oven .
... I f.a.time.other.than.5.hours.or.3.hours.is.
needed,.use.the.number. pads.and.enter.
the.desired.clean.time .
You.can.change.the.clean.time.to.any.time.
between.3.hours.and.5.hours,.depending.on.
how.dirty.your.oven.is .
..Touch.the.DELAY START.pad . .
... U sing.the.number.pads,.enter.the.time.of.
day.you.want.the.clean.cycle.to.start .
..Touch.the.START.pad .
After a Clean Cycle
You.may.notice.some.white.ash.in.the.oven . .
Wipe.it.up.with.a.damp.cloth.after.the.oven.
cools . .
If white spots remain, remove them with a
soap-filled steel wool pad and rinse thoroughly
with a vinegar and water mixture.
These.deposits.are.usually.a.salt.residue.that.
cannot.be.removed.by.the.clean.cycle .
If.the.oven.is.not.clean.after.one.clean.cycle,.
repeat.the.cycle . .
The.upper.and.lower.oven.doors.lock.
automatically . . The.cooktop.elements.are.also.
locked.out.during.self-clean . . The.display.will.
show.the.start.time . . It.will.not.be.possible.
to.open.the.oven.doors.or.use.the.cooktop.
until.the.temperature.drops.below.the.lock.
temperature.and.LOCKED/DOOR.
the.control.display .
When.LOCKED/DOOR.
.goes.off,.you.will.be.
able.to.open.the.doors .
.. Y ou.cannot.set.the.oven.for.cooking.or.
another.self-clean.cycle.until.the.oven.is.cool.
enough.for.the.door.to.unlock .
.. W hile.the.oven.is.self-cleaning,.you.can.touch.
the.CLOCK.pad.to.display.the.time.of.day . .
To.return.to.the.clean.countdown,.touch.the.
SELF CLEAN.pad .
.. I f.the.racks.become.hard.to.slide,.apply.a.
small.amount.of.cooking.oil.to.a.paper.towel.
and.wipe.the.edges.of.the.oven.racks.with.
the.paper.towel .
.goes.off.in.
Need help?
Do you have a question about the Profile PB970SPSS and is the answer not in the manual?