Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu Lifebook T580 User Manual

Memory Upgrade Module

Your Fujitsu LIFEBOOK Tablet PC comes with a minimum of 2 GB of high speed Double Data Rate
Synchronous Dynamic RAM (DDR3-1066 SDRAM) factory installed. To increase your Tablet PC's
memory capacity, you may install an additional memory upgrade module. The memory upgrade must be a
dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only
from the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your Tablet PC, remove any power adapter (AC or auto/airline). Remove the battery.
2
Make sure that all the connector covers are closed.
3
Turn the Tablet PC bottom side up, and remove the screw from the memory upgrade module compartment.
4
Slide the cover towards the battery compartment slightly, then lift it and remove it (Figure 34).
5
Remove the memory upgrade module from the static guarded sleeve.
6
Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade
module with the connector slot in the compartment. Be sure the alignment key is positioned correctly.
(Figure 35)
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
T
O MINIMIZE RISK TO THE MODULE
•
B
EFORE HANDLING A MEMORY MODULE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
•
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
ANY CONTACTS OR CHIPS
;
COMPONENTS THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
•
B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
E
VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP STATES
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
79 - Memory Upgrade Module
.
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
.
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR
:
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH
,
DATA COULD BE LOST OR THE MEMORY
.
(ESD).
.
.