Ip55 / Nema 12K Switched Version - Wiring Diagram For In-Built Switches; Settings For Typical Run / Stop Switch Configurations (Switched Version) - Invertek Optidrive Plus 3GV ODP-12037 Series User Manual

11.7.

IP55 / Nema 12K Switched Version - Wiring diagram for in-built switches

11.8.

Settings for typical Run / Stop switch configurations (Switched Version)

The table below shows the possible configurations that can be achieved by connecting the Purple wire to the designated terminal, and setting
a combination of P1-12 and P2-01. Unless otherwise stated, each of the following configurations utilise the potentiometer mounted on the
front of the IP55S drive (switched variant) for speed variation and control.
Switch Position
Purple Wire in Terminal
1
2 Preset Speed 1
1
2
2
2
2
Optidrive Plus 3
Note:
Purple wire can be moved from
terminal 1 (default) to terminal 2
to give greater functionality
- see table below.
Stop Stop
Stop
Run Reverse Stop
Run in Speed
Stop
Control
Run in Speed
Stop
Control
Run in Hand Stop
Run in Hand Stop
www.invertek.co.uk
GV
User Guide
Fwd / 0 / Rev
Selector
Switch on
Drive
10 kOhm
Potentiometer
on Drive
P1-12 P2-01
Run Forward 0 0
Run Forward 0 0
7, 8, 9,
Run Forward 0
10
Run in PID
3 17
Control
Run in PID
3 11
Control
Run in Auto 4 17
Run in Auto 4 17
(default)
1
2
3
FWD
4
0
5
REV
6
Purple
FWD
7
0
8
REV
9
10
FWD
11
0
REV
Control
Terminals
Notes
Factory Default Configuration
Preset Speed 1 provides a 'Jog' Speed
In Speed Control, Pot controls speed
In PID Control, pot controls setpoint
In Speed Control, P1-11 sets the
Preset Speed
In PID Control, pot controls setpoint
Hand – Speed reference from Pot
Auto – Speed Reference from
Modbus
Hand – Speed reference from Preset
Speed 1
Auto – Speed Reference from
Modbus
Red
Blue
Yellow
Green
White
Black
35