MaxLite MSL Series Operating Instructions

Operating Instructions
MaxLite 2-Head Security Light with Photocontrol/PIR Sensor
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire, electric
shock, falling parts, cuts/abrasions, and other hazards read all warnings and
instructions included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or maintenance
of the luminaires, consult a qualified licensed electrician and check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
• Consult a qualified electrician to ensure correct branch circuit conductor.
WARNING: RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Do not install fixture in the rain to reduce risk of electrical shock.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any
applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
• Not for use with dimmers or 3-way switches. If you have those in place, remove them and replace with
regular electrical switches.
• To avoid damage, do not remove the lens over each LED module.
• Do NOT allow the sensor head to touch the LED head housing. Maintain at least a 1-inch space between
LED heads and sensor head.
• Turn off the switch and circuit breaker before installing this LED light fixture. Do NOT rely upon wall
switch alone to turn off power.
• Use safety precautions. Safety eyeglasses and gloves are recommended.
• Suitable for wet locations.
• Risk of shock, disconnect power before servicing.
• This product must be installed in accordance with the applicable installation code by a person familiar
with the construction and operation of the product and the hazards involved.
• Installation should be performed by a qualified electrician. Please read and understand the entire manual
prior to attempting to assemble, operate or install this product.
• To protect against water damage and maintain proper light operation, the motion sensor adjustment
controls MUST face downward.
• Wall switch must remain ON continually for the motion detector to work.
• If motion is continually detected, then the light will remain on until after motion ceases.
• Installation Height for Suggest: 9-12 ft
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,
servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION: RISK OF FIRE
• Keep combustable and other materials that can burn away from luminaire and lamp/lens
Model:
MSL Series
© Copyright 2024. MaxLite, Inc. All Rights Reserved.
342 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
MSL Series
Picture is for illustration
purposes only.
Your model may vary.
Page: 1
REV: 07/02/24