Table of Contents
Advertisement
DSL-502G ADSL Router User's Guide
PPPoA Connections
The default connection method used by the Router is Point-to-Point-Protocol over ATM (PPPoA). In the PPPoA
Configuration window, you must enter the user name and password for network account authentication and
verification. When this information is entered, the changes must be saved and the Router restarted.
Figure 8. Router/Bridge Configuration - PPPoA
In the Bridge/Router Configuration window, follow these steps to establish the WAN connection using PPPoA:
Under PPPoA Login, enter the Login User Name used for your network account. The user name and login
password, are used to authenticate the identity of the ADSL client and provide access to the service provider's
network. The user name and login password can be any combination of up to 64 characters.
Enter the Login Password.
Unless you are instructed to use a different Authentication method, leave the default chap protocol selected.
The alternative method, pap, can be selected from the pull-down menu if required by the service provider.
Leave the Connect on Demand option as enabled in the pull-down menu. This will allow the Router to
establish a WAN connection upon restarting.
Leave Idle Time set to the default value 0.
22
Advertisement
Table of Contents
