Replacing The Ac Power Supply - Cisco WS-C5509 Hardware Installation Manual

Removing and Replacing the Power Supply
Step 9 Remove the power supply brace by pulling it up and then out as shown in
Figure 4-7
1
2
From the back of the chassis, push the power supply forward, and then lift it up and out.
Step 10

Replacing the AC Power Supply

To replace the AC power supply, perform the following steps:
Insert the new power supply into place and slide it towards the back of the adaptive adaptive security
Step 1
appliance.
Lift the rear of the adaptive adaptive security appliance from the surface and reinstall both screws.
Step 2
Cisco ASA 5500 Series Hardware Installation Guide
4-6
Removing the Power Supply
1
Back panel 3 Power supply brace
4
Power supply Front panel
Chapter 4 Maintenance and Upgrade Procedures
Figure 4-7.
4
3
2
78-17989-01