Headend Certification; Diplex Filters; Receivers - Cisco UBR7225VXR Hardware Installation Manual

Chapter 2 Preparing the Cisco uBR7225VXR Router for Installation
For a VoIP system using H.323, ensure that the CMTS has been properly provisioned with equipment
Note
such as VoIP gateways and gatekeepers. For SGCP-based VoIP systems, ensure that the CMTS has been
properly provisioned with equipment such as VoIP gateways and call-agents.

Headend Certification

The cable headend plant must pass both analog and digital certification:
•
•
The digital certification process is described in
to the Cable Headend."

Diplex Filters

For coaxial cabling, diplex filters must be installed in the RF path between the cable interface cards in
the Cisco uBR7225VXR universal broadband router and cable interfaces and STBs. Diplex filters
separate the downstream signals from the upstream signals.
For fiber optics, laser transmitters and optical receivers handle the frequency separation of upstream and
Note
downstream. Refer to the
High-frequency signals flow in the downstream direction from the Cisco uBR7225VXR router to
cable interfaces and STBs. Low-frequency signals flow in the upstream direction from the
cable interfaces to the Cisco uBR7225VXR router.
A diplex filter has three ports: low, high, and common. The downstream attaches to the high port because
it runs at high frequency. The upstream attaches to the low port because it runs at a low frequency. The
common port attaches to a splitter attached to one or more cable interfaces and STBs.
In two-way cable networks, the diplex filter takes the upstream and downstream and combines them on
one cable for the cable interface. The downstream output signal from the Cisco uBR7225VXR router
runs through the upconverter and then enters the high filter port of the diplex filter. The signal exits the
common port of the filter and is distributed to the cable interfaces. The upstream signal from the cable
modem enters the common port of the diplex filter and flows to the upstream receive ports of the
Cisco uBR7225VXR cable interface line cards through the diplex filters' low port.
Appendix F, "Manufacturers for Headend Provisioning Requirements,"
Note
manufacturers and websites for more information.

Receivers

If the upstream channels of your cable plant terminate at the headend over fiber-optic lines, ensure that
you have a receiver allocated for each upstream in your network.
OL-17309-01
In the United States, the Federal Communications Commission (FCC) mandates minimum technical
performance requirements for cable systems.
For international requirements, consult with local agencies for certification requirements.
"Receivers" section on page
Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide
Chapter 4, "Connecting the Cisco uBR7225VXR Router
2-11.
provides a list of diplex filter
Provisioning the Cable Headend
2-11