Installation Tools; Rack-Mount And Cable-Management Kit - Cisco UBR7225VXR Hardware Installation Manual

Installation Tools

•
•
•
•
•
•

Installation Tools

Your Cisco uBR7225VXR universal broadband router chassis is fully assembled at the factory; no
assembly is required. However you will need the following tools and equipment to install the chassis and
the rack-mount and cable-management kit:
•
•
•
•
•
•

Rack-Mount and Cable-Management Kit

The rack-mount and cable-management kit includes the following parts:
•
•
•
•
•
For more information on the rack-mount brackets and cable-management bracket, refer to the
"Cisco uBR7225VXR Router Chassis Rack-Mounting Options" section on page
Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide
2-8
Dial-up access telephone numbers, usernames, and passwords for telco return operation.
RADIUS security and accounting configuration.
Gateway and gatekeeper zone configuration for your H.323 VoIP network.
Gateway and call-agent configuration for your SGCP VoIP network.
Zone names, network numbers, or node numbers for the new interfaces, if required.
Operating speeds for specific interfaces—For example, serial interfaces operate at speeds of up to
2 Mbps. The speed of an interface often depends on the speed of the remote device to which it is
attached.
Number 2 Phillips screwdriver
3/16-inch flat-blade screwdriver
7/16-inch flat-blade screwdriver
7/16-inch torque wrench for connecting coaxial cables to the cable F-connectors on the
cable interface line cards—Recommended torque is 20 inch-pounds (optional)
Tape measure (optional)
Level (optional)
Two rack-mount brackets for mounting the chassis in the rack.
Cable-management bracket to relieve the strain on installed cable interface line card interface
cables.
Eight M4 x 6-mm Phillips flathead screws to secure the rack-mount brackets to the chassis.
Four M3 x 6-mm Phillips panhead screws to secure the cable-management bracket to the chassis.
Four 10/32 x 3/8-inch slotted binderhead screws to secure the rack-mount brackets to the rack rails.
Chapter 2 Preparing the Cisco uBR7225VXR Router for Installation
3-2.
OL-17309-01