Verifying The Hardware Installation - Cisco SLM248P Quick Start Manual

If you have changed the switch IP address or are using DHCP to
N
OTE
assign it, enter the new IP address assigned to the switch. The
ip address of the computer you are using to configure the
switch, must be on the same subnet as the switch.
When the login page appears, enter the user name and password.
S 4
TEP
The default user name is
Passwords are case sensitive.
Click Login.
S 5
TEP
Follow the on-screen prompts to complete the initial configuration.
S 6
TEP
4
Troubleshooting and
Suggested Next Steps

Verifying the Hardware Installation

To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in
page 1.
• Connect a computer to an available LAN port and verify that you can
connect to a website on the Internet, such as www.cisco.com.
If you encounter problems, consider the following:
• Reset the switch to its factory default settings by holding down the
reset button for 10 seconds.
• Set a temporary IP address on an attached device within the range of
X
192. 1 68. 1 .
• Use the ping utility to verify connectivity.
Cisco Small Business SLM Series Smart Switch Installation Guide
and subnet mask of 255.255.255.0.
admin
. The default password is
Getting to Know the Switch,
admin
.
7