Cisco SLM248P Quick Start Manual page 3

To establish a Fast Ethernet connection using a miniGBIC port, you will
need to install a MFEFX1 (100BASE-FX) or MFELX1 (100BASE-LX) 100SFP
transceiver and use fiber optic cabling.
On the SLM2024 and SLM2048, miniGBIC ports are shared with
N
OTE
standard ports. If a miniGBIC port is used, then the shared
standard port on the switch cannot be used. The following table
defines the shared port mapping of the SLM2024 and SLM2048
switch.
Switch Model
SLM2024
SLM2024
SLM2048
SLM2048
SLM248G, SLM248P, SLM224G, and SLM224P
The following section describes the SLM248G, SLM248P, SLM224G, and
SLM224P switches. The front panel of the SLM248P is shown.
Front Panel
PoE — (Amber) Blinks to indicate that power is being supplied to a device
attached to the corresponding port. PoE is available on:
• SLM224P ports 1-6, and 13-18
• SLM248P ports 1-12, and 25-36
100M (1-24 or 1-48) — (Amber) Appears on the "G" models of the switch
on each port, and lights up to indicate a functional 100 Mbps connection on
the corresponding port with an attached device. Appears on the "P"
models of the switch only on the non-PoE ports:
• SLM224P ports 7-12, and 19-24
• SLM248P ports 13-24, and 37-48
Gigabit — (G1-G2) (Amber) Lights up to indicate a functional 1000 Mbps
connection on the corresponding port (G1-G2) with an attached device.
2
miniGBIC Port
miniGBIC 1
miniGBIC 2
miniGBIC 1
miniGBIC 2
Cisco Small Business SLM Series Smart Switch Installation Guide
Standard Port
Port 12
Port 24
Port 24
Port 48