3. PERSONAL SAFETY for misalignment or binding of moving parts, a) Stay alert, watch what you are doing and use breakage of parts and any other condition common sense when operating a power tool. Do Cordless Chain Saw WG322E WG322E.X...
This will ensure that the safety of the either break or increase the chance for kickback. power tool is maintained. k) Cut wood only. Do not use chain saw for purposes b) Never service damaged battery packs. Service Cordless Chain Saw WG322E WG322E.X...
Battery pack needs to be charged before use. c) Only use replacement bars and chains specified Always refer to this instruction and use the by the manufacturer. Incorrect replacement guide correct charging procedure. Cordless Chain Saw WG322E WG322E.X...
Page 11
Recharge only with the charger specified by wood keeps the tree from twisting and falling in the Worx. Do not use any charger other than that wrong direction. Do not cut through the hinge. specifically provided for use with the equipment.
Page 12
(2) the lower 2/3 to meet the first cut. Fig.5 Wear eye protection Wear dust mask Do not expose to rain Wear protective gloves Fig.6 Fig.6 When bucking on a slope always stand on the uphill Fig.6 Cordless Chain Saw WG322E WG322E.X...
Page 13
Batteries may enter water cycle if disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted municipal waste. Beware of chain saw kickback and avoid contact with bar tip Cordless Chain Saw WG322E WG322E.X...
COMPONENT LIST TECHNICAL DATA Type WG322E WG322E.X (3 - designation of machin- REAR HANDLE ery, representative of chain saw) ON/OFF SWITCH WG322E WG322E.X ** OIL FILLER CAP Voltage Max*** FRONT HANDLE Bar length 25cm HAND GUARD Chain speed 3.8m/s GUIDE BAR...
2. Place the chain saw on a solid, level surface. accordance with a standard test method and may be 3. Use only genuine Worx chains or those used for comparing one tool with another. recommended for Guide Bar.
If there is no oil pattern, despite a full machine. (See Fig. E2) oil reservoir, contact Worx customer service agent or NOTE: The Chain (7) is properly tensioned when it can Worx approved service agent.
Page 17
Never use the chain saw above shoulder height movement) of saw. 7) Guide the saw using light pressure and do not put CUTTING WOOD UNDER TENSION (See fig. L) excessive force on the saw, letting the saw do its Cordless Chain Saw WG322E WG322E.X...
Have damage saw in the repair parts list or on the decal located on repaired by authorized service center. To locate an the chain saw. authorized service center, visit www.worx.com 3. Maintain chain saw with care. Replacing Bar & Chain •...
The ambient temperature range for the use and storage of tool and battery is 0°C-45°C. The recommended ambient temperature range for the charging system during charging is 0°C-40°C. Positec Australia Pty Ltd 10 Corporate Blvd Bayswater, VIC 3153, Australia Cordless Chain Saw WG322E WG322E.X...
Chain tension too loose Adjust chain tension vibrates, does not Dull chain Sharpen chain or replace saw properly Chain worn out Replace chain Chain teeth are facing in the wrong Reassemble with chain in correct direction direction Cordless Chain Saw WG322E WG322E.X...
Positec Germany GmbH Postfach 32 02 16, 50796 Cologne, Germany On behalf of Positec declare that the product Description Battery-powered chain saw Type WG322E WG322E.X (3 - designation of machinery, representative of chain saw) Function Cutting wood Complies with the following Directives: 2006/42/EC, 2014/30/EU 2011/65/EU&(EU)2015/863...
Page 22
Positec (UK & Ireland) Ltd, PO Box 6242, Newbury, RG14 9LT, UK On behalf of Positec declare that the product Description Battery-powered chain saw Type WG322E WG322E.X (3 - designation of machinery, representative of chain saw) Function Cutting wood Complies with the following regulations:...
Need help?
Do you have a question about the WG322E and is the answer not in the manual?
Questions and answers