Core 40104 Quick Start Manual

Instant Shelter Sun Wall
Compatible with 10 ft × 10 ft
Level Area
Rubber Mallet
2 People
1
Extend Shelter Frame
Set up the 10 x 10 Instant Canopy according to the instruction that came with that product.
2
Attach Sun Wall
NOTE: The Sun Wall may be attached to any of the 4 sides of the Instant Canopy.
Clip J-HOOK located at each top corner of the Sun Wall onto the METAL LOOP at the top of the LEG POLES. (fig. 1)
Wrap J-hook and D-ring on straps located at top of Sun Wall around TOP FRAME to secure. (fig. 2)
Wrap J-hook and D-ring on straps located along one side of the sun wall around leg pole to secure. (fig. 3)
Clip one of the two J-HOOKS located near the bottom edge of the Sun Wall into the hole in the lower LEG POLE. Use the lower J-HOOK (A) when
the LEG POLE is fully extended and J-HOOK (B) for lower LEG POLE height setting. (fig. 4)
Repeat above steps to secure other side of the Sun Wall.
Place METAL STAKE through the WEB STRAP located at each bottom corner and center of the Sun Wall then drive in to secure. (fig.5)
Setup Tips
• Clear your camp area of debris before setting up your shelter.
• Remove all protective cardboard and foam inserts around the center hub before initial setup
• Set up shelter at home before getting to the campsite.
• Take a few extra moments to setup each section of your shelter with care
1
2
5
Instant Shelter
Core Instant Tech nology:
®
Pre-attached poles that telescope and
click into place ensure a quick setup
NOTE: 2 people will be needed to erect
and extend the shelter poles
3
B
4
A
Model #40104