Danby Simplicity SPAC8499 Owner's Manual page 34

Setting the AUTO-ON TIMER (cont'd)
5) All of the settings are now registered. TURN
THE UNIT "OFF" USING THE I/O SWITCH.
6) To set the AUTO-ON timer, the unit must be
turned to the "off" position (non-operational).
7) Press the TIMER-ON key pad to initiate the
AUTO-ON time sequence. Fig. 32. The display
window will indicate TIMER-ON and the word ON
will flash for 5 seconds. Press the
to select the desired AUTO-ON start time.
Fig. 32a.
key pad will decrease the AUTO-TIMED
setting in 10 minute increments.
keypad will increase the AUTO-TIMED
setting in 10 minute increments.
When the desired time is established, (the time
will flash in the display window) press the
CLOCK key pad to register the AUTO TIMER-
ON program. The word ON will stop flashing and
remain "on" (TIMER ON) indicating the program
is set. The time of day clock setting will
immediately revert back in the display window.
IMPORTANT: The desired AUTO-ON time must
be registered within a 5 second period (after
pressing the TIMER-ON key pad) otherwise the
selected time will not register and the system
will automatically revert back to the regular
"time of day" clock setting. If this occurs, you
must repeat step 7 again.
The unit will start automatically when the specified
AUTO-ON time is achieved on the time of day clock
(the "TIMER ON" prompt will disappear from the
display window). To cancel or override the AUTO-
TIMED program, simply turn on the unit before the
AUTO-ON time is scheduled to operate (the "TIMER
ON" prompt will disappear from the display window).
You can varify the AUTO-ON time selection anytime
(prior to the program starting) by pressing the
TIMER-ON key pad. The time you selected will
appear (flash) temporarily (replacing the time of day)
for approximately 5 seconds.
TIMER
or key
Water Full
Cool/Heat/Dry
TIMER
Water Full
Cool/Heat/Dry
16
I/O
12:00
ON
FAN
SWING
I/O
12:00
ON
FAN
SWING
MODE
TEMP./CLOCK
ADJ.
ON
TIMER
OFF
CLOCK
Fig. 32
MODE
TEMP./CLOCK
ADJ.
ON
TIMER
OFF
CLOCK
Fig. 32a