Bridge Commands - Asus GigaX2124X User Manual

GigaX Series L2 Managed Switch User's Guide
[Reload]
Restores the previous port settings from the configuration file.
CLI command : sys l2 port retrieve
5.3.3

Bridge Commands

[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
Allows user to specify whether the switch participates the Spanning Tree
Protocol (STP/ RSTP).
CLI command : l2 stp start <stp / rstp>
CLI command : l2 stp stop
[Hello Time]
[Forward Delay]
[Max Age]
[Bridge Priority]
Displays the current STP/RSTP bridge parameters setting.
CLI command : l2 stp bridge set
Hello Time (1..10 seconds):[old Hello Time] <new Hello Time>
Max Age (6..40 seconds):[ old Max Age] <new Max Age>
Forward Delay (4..30 seconds):[ old Forward Delay] <new Forward
Delay>
Bridge Priority (0..65535):[ old Bridge Priority] <new Bridge Priority>
[Priority]
[Path Cost]
[Edge Port]
[Point-to-point]
Displays the current STP/RSTP ports parameters setting.
CLI command : l2 stp port set
Port Settings (all,...):[all] <select a port number, or just type 'all' to
iteratively config>
74