Advertisement
8. If WEP is enabled on your wireless
network, select the Encryption
Mode (e.g. 64-bit, 128-bit), the Key
Format (e.g. Hex, ASCII) and the
Default Key (e.g. Key_1, Key_2,
Key_3, Key_4). Then enter the
encryption key in the Key1, Key2,
Key3 or Key 4 field. Then click the
right arrow.
If WPA is enabled on your wireless
network, enter the encryption key
in the Pre-Shared Key field and
then click the right arrow button to
continue.
Note: If you do not know your
encryption key, contact your
network administrator for more
information
9. Copy down the IP Address. Then
click the reboot button to save
settings.
10. Disconnect the RJ-45 cable and
unplug the power. Then plug the
power back in (TV-IP100W-N).
Note: The TV-IP100W-N will not work wirelessly until you disconnect the
Ethernet cable from the back of the camera.
6
English
Advertisement
