Making A Recording - Extron electronics RCP 401 D Setup Manual

Making a Recording

Once the SMP 401 and RCP 401 D are installed, and configured, follow these instructions to make
a recording using the RCP 401 D:
1.
Open the SMP 401 web page to ensure the recording will be saved to the correct drive and
that the recording media is attached to the correct drive.
2.
If required, select a different layout by pressing the LAYOUT button (see figure 8,
3.
Use the RCP 401 D to start the recording by pressing the Record button (
4.
If required, add a chapter marking by pressing the MARK button (
5.
If required, pause the recording by pressing the Pause button (
Restart the recording by pressing the Pause button a second time or by pressing the Record
button.
6.
End the recording by pressing the Stop button (
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
and Regulatory Compliance Guide
6
).
B
on the Extron website.
© 2024 Extron — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
).
E
).
A
).
D
).
C
www.extron.com
RECORD
A B
C MARK
D
E
SWAP LAYOUT
USB STORAGE
e
Figure 8. RCP 401 D Front Panel
Extron Safety
68-3399-50 Rev. A
09 24