INSTALLATION INSTRUCTIONS
TOILET SEAT
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly,
please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your
installation conforms to local codes.
NOTE: Pictures may not exactly depict toilet seat and components.
Side view of the toilet seat installation parts.
Hinge
Cover
Plastic
Bolt
Adjustment
Washer
Hinge
Gasket
2
The installation kit includes two sets of stainless washers:
2 with center holes and 2 with offset holes. The offset
washers hole can be set forward or back allowing the
seat to be moved back from or to the forward edge of
the bowl rim.
To Move
Seat Forward
FRONT OF BOWL
4
With the plastic bolts installed, thread the
winged plastic nuts on to the bolts.
All product names listed herein are trademarks of AS America, Inc. unless otherwise noted.
© AS America, Inc. 2015
BOTTOM MOUNT
1
Hinge
Under Hinge
Attach Hinge Gaskets to bottom of Hinge Base.
Plastic
Make sure Alignment Tabs on Hinge Gaskets
Wing Nut
match the slots under the Hinge Base.
TANK
To Move
Seat Back
5
Tighten the bolts using a screwdriver.
Slot Alignment
Tab
Hinge
Base
Gasket
3
When the seat is properly aligned with the
front edge of the bowl shlip the bolt through
the washer and the bowl bolt holes.
Align hinges over holes on toilet bowl.
6
The hinge cap covers are designed to snap
lock on to the hinge. Position the hinge
covers and push down on the cover.
7302106-100 Rev. C 2/15
Need help?
Do you have a question about the 5359C051H.020 and is the answer not in the manual?
Questions and answers