Phase Invert - MSB Technology The Select DAC User Manual

Saving Menu and Startup Settings
When changing settings in the menu, use the enter button in the
center of your volume wheel on the remote or the right arrow on the
Digital Director to confirm settings in the menu. In oder to save the
changes you have made in the menu, use the "menu button" to exit
the menu completely.
The DAC will not save any of your settings until you exit the menu.
Certain buttons on your remote will change settings on your system
without navigating the menu, such as: Phase Invert, Display Modes,
and Video Mode. However, these settings reset every time the system
is reset or powered off. If you would like these settings to persist
through resets or power offs, you simply have to choose the action
button setting that you wish to make the default. Then, enter and
exit the menu by double clicking the Menu button on your remote or
Digital Director.
If at any point the system seems to be improperly setup or you want
to start fresh with your settings and functions, there is a "Reset" option
near the end of the menu. Simply select this and confirm "YES" before
leaving the menu.

Phase Invert

The Phase Invert button is located on the remote to allow the user an
easy way to invert the audio phase. This is a situational feature that is
not always needed, but it can be used to fix certain recording or system
setup requirements.
Video Mode
The Video Mode button is located on the remote to reduce signal latency
and compensate for lip-sync delays when using the DAC for video
playback. This should only be used for video playback as it increases
unwanted jitter in the system.
12