TRENDnet TEW-684UB Quick Installation Manual page 10

3. Windows is unable to recognize my hardware. What should I do?
1. Make sure your computer meets the minimum requirements as specified in Section 1 of this
quick installation guide.
2. You must complete the installation installation of the TRENDnet Wireless Utility (as described in
Section 2) before connecting the Wireless USB Adapter to your computer.
3. Connect the Wireless USB Adapter to a different USB port on your computer.
4. Verify the USB Adapter's LEDs are working properly. Please see the table below:
LED/Button
Power
Wireless Link/Act LED
WPS
WPS LED
WPS Button
4. I cannot open the TRENDnet Wireless Utility. What should I do?
Access your device manager to make sure the adapter is installed properly.
1. To access the device manager on Windows 7, click on the Windows icon on the bottom left-hand
corner, click Computer, click System Properties and then click Device Manager.
2. To access the device manager on Windows Vista, right-click Computer, click Properties and
then click Device Manager.
3. To access the device manager on Windows XP, right-click My Computer, click Properties, click
the Hardware tab, and then click Device Manager.
If you see a networking device with a yellow question mark or exclamation point:
1. Uninstall the device from device manager
2. Remove the adapter from the computer
3. Click the Windows / Start icon, click All Programs, click TRENDnet and then click Uninstall.
4. Reinstall the adapter. See Section 2. How to Install.
If you still encounter problems or have any questions regarding the TEW-684UB, please refer to the
User's Guide included on the Utility & User's Guide CD-ROM or contact TRENDnet's Technical Support
Department.
Sequence
Color
Green
On
N/A Off
Green On
Green Blinking
N/A Off
Green On
Green
Blinking
N/A Off
N/A
N/A
8
Definition
Device is on
Device is off
Wireless LAN is on or enabled
Wireless data transmission
Wireless LAN is off or disabled
WPS authentication process is complete
WPA authentication prociess is ongoing
WPS is not activated or disabled
Hold 3 seconds to activate WPS