Table of Contents
Advertisement
-Log into your wireless access point's user interface and start the access point's WPS push
button configuration. Please refer to the wireless access point's manual on how to initialize
WPS Push Button Config.
The LED will begin to blink during authentication. Once the connection has been successfully
establish the LED will remain solid.
Note: Most wireless access points have a physical WPS button. Pressing the button will
initialize WPS Push Button Config.
PIN Code
For PIN Code configuration the user is required to log into the wireless access point's user
interface and follow the steps below. Please refer to the wireless access point's manual on
how to initialize WPS Push Button Config.
-Open the wireless utility and select "Wi-Fi Protected Setup" tab.
-Click on "Pin Input Config (PIN)" button. You will be prompted to select your wireless access
point's SSID. Click yes if you are aware of the access point's SSID.
-Log into the wireless access point's user interface and input the PIN Code information
provided on the wireless utility
-Initialize the wireless access point's WPS PIN configuration.
13
Advertisement
Table of Contents
