mitzi MARGOT SWAG HL270701L Assembly And Mounting Instructions

ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
•
WARNING-ALWAYS UNPLUG THE LAMP TO CUT ELECTRIC
POWER OFF BEFORE INSTALLING, CLEANING, OR OTHER
MAINTENANCE.
•
FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN
SERIOUS INJURY OR DEATH
INSTALLATION
STEP 1.
Remove the table lamp and parts from the Carton.
STEP 2. Drill a hole into the ceiling then attach the screw through
the inner cap and thread it to the wings.
STEP 3. Push the cap into through the hole and tighten it use the
screw.
STEP 4. Thread the hook onto the inner cap. Hanging the cord
with the fixture on the hook, then secure it with set screw.
STEP 5. Put the glass shade onto the glass fitter then secure it
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products
ASSEMBLY AND MOUNTING DIAGRAM
www.hudsonvalleylighting.com/mitzi| #mymitzi
HL270701L, HL270701S MARGOT SWAG
•
READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
•
BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
with the socket ring.
STEP 6. Install the lamp. The fixture is rated for 60 watt G lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
STEP 7. Plug cord into a qualified socket of properly rated
voltage.