Listening To The Radio; Auto Tuning; Manual Tuning - Denon AVR-4806 Operating Instructions Manual

3
CURSOR
Press the
volume of the front channels, the
button to reduce the volume of the rear
channels.
Example: When "FRONT" is selected
The fader function does not affect the subwoofer
channel.

Listening to the Radio

• Check that the remote control unit is set to AMP or TUNER.

Auto tuning

1
Set the input source to "TUNER".
(Main unit) (Remote control unit) (Remote control unit)
2 TUNER
Press the
select the TUNER mode.
3
Watching the display, press the
to select the desired band (AM or FM).
4
MODE
Press the button to set the auto tuning
mode.
• "Auto" appears on the display.
5
TUNING
Press the
• Automatic searching begins, then stops when a
station is tuned in.
• If tuning does not stop at the desired station, use to the
"Manual tuning" operation.
F F button to reduce the
CURSOR
button to
(Remote control unit)
BAND
button
button.
G G
• The channel whose channel level is adjusted lowest can be
faded to –12 dB using the fader function.
• If the channel levels are adjusted separately after adjusting
the fader, the fader adjustment values are cleared, so adjust
the fader again.

Manual tuning

1
Set the input source to "TUNER".
(Main unit)
2 TUNER
Press the
select the TUNER mode.
3
Watching the display, press the
to select the desired band (AM or FM).
4
MODE
Press the
mode.
Check that the display's "AUTO" indicator turns off.
5
TUNING
Press the
station.
The frequency changes continuously when the button
is held in.
• When in the auto tuning mode on the FM band, the
"STEREO" indicator lights on the display when a stereo
broadcast is tuned in. At open frequencies, the noise is
muted and the "TUNED" and "STEREO" indicators turn off.
• When the manual tuning mode is set, FM stereo broadcasts
are received in monaural and the "STEREO" indicator turns
off.
65
Basic Operation
(Remote control unit) (Remote control unit)
button to
(Remote control unit)
BAND
button to set the manual tuning
button to tune in the desired
button